Blackmagicdesign SmartView Duo Manuel d'instructions télécharger pdf (Page 8)

Getting Started

Optimizing the Viewing Angle

Before you install SmartView high up in a rack, it is a good idea to check the optimum viewing angle by

connecting an SDI video signal and then temporarily inverting the unit. The unit will automatically sense the

inversion and ﬂip the video images to the correct orientation.

The following procedure describes how to invert the unit while keeping any labelling in the correct

orientation on the front face plate. A number 02 size Pozidriv screwdriver is required.

Step 1. Remove the screws from the top, bottom, left and right sides of SmartView. SmartView Duo has

10 screws and SmartView HD has 18 screws.

Step 2. Lift the front face plate away from the rear assembly as illustrated.

You may wish to perform a test inversion, to check the optimum

viewing angle, before bolting SmartView high up in a rack.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 32 33

Pas de commentaire

Blackmagicdesign SmartView Duo Manuel d'instructions Page 8