Blackmagicdesign SmartView Duo Manuel d'instructions télécharger pdf (Page 5)

Getting Started

A tally connector is provided for use with switcher and automation systems. The 9-pin D connector wiring

description is printed on the rear of the unit showing contact closures to display red, green or blue tally

borders on each, independent monitor.

If SmartView is to be installed high up in an equipment rack, you may wish to physically invert the LCDs

for the optimum viewing angle. The images on the LCDs will automatically ﬂip to the correct orientation

when they sense an inversion. A number 02 size Pozidriv screwdriver is required to disconnect and

reconnect the faceplate from its rear assembly. This is a simple procedure and does not involve opening the

rear assembly.

SmartView includes a universal power supply with international power socket adapters for all countries.

To stop power from being accidentally disconnected, a cable tie point is included just below the power

socket to lock down the power connection. You will need to provide a mains power socket for the universal

power supply.

1 2 3 4 5 6 7 8 9 10 ... 32 33

Pas de commentaire

Blackmagicdesign SmartView Duo Manuel d'instructions Page 5