Blackmagicdesign SmartView Duo Manuel d'instructions télécharger pdf (Page 17)

Getting Started

Updating the Firmware in Your SmartView

Once the software installation has been completed and SmartView is powered on, it is a good idea to check

that the ﬁrmware in the SmartView is up to date.

Step 1. Launch the Blackmagic SmartView Utility.

Step 2. Connect your SmartView unit to the computer via USB 2.0.

Step 3. If no ﬁrmware update is required, you will simply see the settings used by your SmartView. Settings

can be changed now if desired and this is a good opportunity to give each SmartView a unique

"Device Name". Please skip the rest of the steps in this section as your SmartView is already up to

date.

If a ﬁrmware update is required, the following message will appear: "Firmware Update Required. The

ﬁrmware on this device is out of date. Would you like to update it now?" Click

Yes. The update will take

4 or 5 minutes to complete.

Step 4. The message, "The ﬁrmware has been successfully updated," should appear at completion of

the update. Click

OK to dismiss the message. Settings can be changed now if desired and this is a

good opportunity to give each SmartView a unique "Device Name".

Step 5. You can now unplug the USB cable from your SmartView.

This message will appear if a ﬁrmware update is required.

The update will take about 4 or 5 minutes to complete.

Blackmagic SmartView Utility application icon

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 32 33

Pas de commentaire

Blackmagicdesign SmartView Duo Manuel d'instructions Page 17